along with Shenyang gas filling block Equipment production lines are widespread, we are in Shenyang Aerator block More and more problems have been found in the production of the equipment. In the meantime, we found the following problems in the practice of residual impurities in the production:

Impurities left on the mold

The large particles of impurities left on the mold will be directly attached to the surface of the green body. When cutting, they will cause harm to the cut steel wire or directly hang on the steel wire, causing damage to the green body or the specification error of the green body, etc. Severe times may also cause the occurrence of steel wire cracking.

Impurities in mortar

During the use of waste slurry, there may be impurities in it. When it enters the slurry tank, it is not properly treated, which forms the residue of impurities. These impurities will directly appear in the green body, and affect the green body, as well as the cutting process, and affect the product qualification rate.

These are two common manifestations of residual impurities in the production of Shenyang aerated block equipment. In order to avoid residual impurities, we need to filter the pouring mortar strictly, and at the same time, carefully clean Shenyang aerated block. The problem of Shenyang aerated block equipment should not be caused by a small amount of impurities, resulting in product quality disqualification.

Shenyang gas filling block equipment production line only needs qualified products, which can be certified by builders, and can be applied to buildings in the future. We know that the production of high-quality Shenyang gas filling block equipment products is not only based on the quality of the equipment, but also on the operating know-how of the staff. The manufacturers that customers choose to invest in are all suppliers of equipment and training for customers. However, we know that training is short after all, and only tells customers about the production process. The detailed process still requires customers to gather more experience in their usual production. Here, we also need to do more to know some common sense about the production of products. The operation of blending technology in the production line of Shenyang gas filling block equipment is very cautious. With reasonable blending and reasonable production process of equipment, it is believed that the quality of gas filling products produced will be perfect.

Before starting up the batching control post of Shenyang gas filling block equipment, admit that the air compressor is operating and ensure that there is sufficient air pressure. The operator shall turn over the control power supply, turn over the host, turn over the production screen, select the ratio scheduling, input the ratio supplied by the Quality Control Department, input the ratio when, and the single production. Admit again whether the ratio is accurate. Click Initial Production to check whether the measured data is consistent with the matching. If not, close the production screen and set the matching from the beginning. After the setting is accurate, turn over the allowable weighing, allow unloading, and initially automate production. After configuration, when the production of raw materials for blocks produced by Shenyang aerating block equipment is completed, the allowable weighing and unloading shall be turned off, all knobs shall be turned to the stop position, the production screen shall be pushed out, the computer shall be turned off according to the normal sequence, and the power supply of the console shall be turned off.

It is easy to have big questions about perfunctory work, so no matter what kind of work you do, you should not be careless. For a job, you only need to work carefully and patiently, and the power completed must be different, so it is very important to be careful. This is true for a small matter. Besides, it is also true for a project with such a huge amount of investment in the production line of aerated concrete equipment.

The content of this article comes from the network. If you have any questions, please contact me to delete it!