Sand aerated block Installation and maintenance of
Installation and maintenance The maintenance of the machine is an important regular work, which should be closely coordinated with the operation and overhaul, and should be checked by full-time personnel on duty
1、 Installation and commissioning:
1. The equipment shall be installed on a horizontal concrete foundation and fixed with anchor bolts.
2. During installation, pay attention to the perpendicularity of the main body to the horizontal.
3. After installation, check whether the bolts at each part are loose and whether the main engine compartment door is fastened. If yes, tighten it.
4. Configure the power cord and control switch according to the power of the equipment.
5. After inspection, carry out no-load test run. If the test run is normal, start production.
2、 Maintenance of the machine:
1. The bearing bears all the loads of the machine, so good lubrication has a great impact on the bearing life, which directly affects the service life and running rate of the machine. Therefore, the injected lubricating oil must be clean, and the seal must be good. The main oil injection place of the machine (1) is the rotating bearing (2) is the roller bearing (3) is all gears (4) is the movable bearing and sliding plane
2. The newly installed tyre is easy to loosen and must be checked frequently
3. Pay attention to whether all parts of the machine work normally
4. Pay attention to check the wear degree of easily worn parts and replace the worn parts at any time
5. Dust and other materials shall be removed from the chassis plane of the movable device to prevent the movable bearing from moving on the chassis when the machine encounters unbreakable materials, which may lead to serious accidents
6. If the bearing oil temperature rises, stop the machine immediately to check the cause and eliminate it.
7. If there is an impact sound when the rotating gear is running, stop it immediately for inspection and eliminate it
The content of this article comes from the network. If you have any questions, please contact me to delete it!
