Light brick partition wall refers to a non load bearing wall for building partition formed by using light bricks or light blocks with special adhesives. Because of its light weight, high strength, water resistance, fire resistance, sound insulation, heat insulation, green environmental protection and fast construction, it has been strongly supported by the national wall reform policy and widely recognized by the market for many years, and has become an important part of new building materials.

Light brick or light block: refers to the brick or block with small unit weight and certain compressive strength. For example: Autoclaved aerated concrete blocks (also called aerated block and Yitong brick).

Scope of application: It is used for hotel partition, KTV box partition of entertainment club, office partition, etc.

The application range of aerated brick is very wide, which can be used as load-bearing materials, non load-bearing materials or maintenance filler materials such as walls, floors and roof slabs of industrial plants and civil buildings. All these advantages and the premise of application are to ensure the quality of aerated bricks. The quality of aerated bricks has always been a concern of enterprises. Only good product quality can win the market and gain profits, so the following section will tell you how to effectively improve the yield of aerated bricks.

1. When cutting the steel wire to cut the end of the green body, it is necessary to prevent the steel wire from suddenly collapsing out of the green body and causing damage to the edges and corners of the green body. Therefore, it is required that the steel wire should preferably form a certain angle with the billet, and the special support mechanism should also be considered to protect the external surface of the billet.

2. The slurry shall be mixed evenly, and uneven mixing will lead to uneven hardness of aerated brick embryo, which will result in too long static stop time or too fast hardening, and it is not easy to demould.  

3. The mold bottom of the mold frame shall be cleaned and the oil shall be evenly coated, otherwise the internal part of the mold frame may be dry Aerated concrete block Embryo collapse.

4. When turning over, once the whole mold frame can not be completely demoulded in time, the edges and corners of the green body will also be damaged. At this time, the cutting machine should use special steel wire to cut, which is also a method to prevent the aerated bricks from sticking together after cutting. In addition, the requirements of the cutting machine on the mold frame should be evenly oiled in order to facilitate the timely demoulding of the green body.

5. During cutting, it is necessary to prevent the embryo body from breaking at one end due to lack of support or inadequate support when the embryo body is cut to the end, or the edges and corners of the embryo body from the top to the bottom when the steel wire runs from top to bottom.

The above is all about how to effectively improve the yield of aerated bricks. As long as you pay attention to the above problems, the yield of aerated bricks will also be greatly improved.