Sand aerated block It is a new type of environmental protection material, which is increasingly used in building construction. The production of aerated blocks requires professional production equipment, but the noise of such equipment is generally high. I believe many people are very worried about this problem. Today we will see how to solve this problem.

It is impossible to completely remove the noise from the production equipment of sand aerated block. It can only be improved by some methods. First, improve the operation method to reduce the noise. Third, the beautification and improvement of the environment can also reduce the noise. Different planting density can make the tree density and concavity reasonable to reduce the noise. Finally, earplugs, earmuffs and noise helmets can also be used for personal protection to reduce noise.

Installation construction process and technical points:

1、 Clean the installation site. The top plate, floor plate surface and structural wall surface of the light partition board to be installed shall be thoroughly cleaned to ensure that the concrete structural surface contacted by the partition board installation is flat and dense.

2、 Survey the project and set out. According to the design and construction drawings, measure and set out the side line of light partition board as the installation basis.

3、 According to the plate arrangement drawing of the survey results, the U-shaped steel plate clamp shall be fixed on the top plate with nails at the upper end of the batten seam in advance.