Autoclaved aerated concrete blocks Manufacturer's introduction Autoclave Aerated concrete block Separate wallboard, roof panel, exterior wall panel, floor slab and other functional plates according to their functions, which is economical and environmentally friendly.

Application range of autoclaved aerated concrete blocks: applicable to non seismic areas and areas with seismic fortification intensity of 6 to 8 degrees; It is applicable to the internal partition walls of middle grade buildings, middle grade and higher grade buildings; It is applicable to the external wall, internal partition wall and roof of various steel structure and reinforced concrete structure industrial and civil buildings; It is applicable to the internal and external infilled walls above the air (± 0.000) and below the air (except for the walls with special requirements) of various buildings.

Notes on application of autoclaved aerated concrete blocks:

1. Autoclaved aerated concrete blocks shall not be built on the floor or in the air. With regard to the root of the wall which is often subject to the alternating action of dry and wet, such as the toilet, terrace, external balcony, and the contact part between the air conditioner bearing plate and the masonry on the external wall, C20 plain concrete wall pads with the same width as the wall thickness and a height of not less than 0.2m should be poured; For other walls, autoclaved lime sand bricks should be used to build a wall mat with a height of not less than 0.2m at the root.

2. Autoclaved aerated concrete blocks shall not be used in the following parts: the parts of the building below ± 0.000 (except the indoor infilled wall of the open room); Parts that have been immersed in water for a long time or often alternate dry and wet; Environments subject to chemical corrosion, such as strong acid, strong alkali or high concentration of carbon dioxide; The masonry surface is often in a high temperature environment above 80 ℃.

The content of this article comes from the Internet. If you have any questions, please contact us!